Arp scan over a vpn

Home Forums Arp scan over a vpn

This topic contains 0 replies, has 1 voice, and was last updated by  BrianMiz 4 days, 3 hours ago.

  • Author
    Posts
  • #133374

    BrianMiz
    Member

    Hi All,

    I am trying to run an arp scan from my host machine whilst connected to a VPN. Here is the relevant bit of my configuration:

    “`
    $ ip a
    1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
    valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host
    valid_lft forever preferred_lft forever
    2: wlo1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
    link/ether 50:eb:71:37:61:76 brd ff:ff:ff:ff:ff:ff
    inet 192.168.1.86/24 brd 192.168.1.255 scope global noprefixroute wlo1
    valid_lft forever preferred_lft forever

    8: tun0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UNKNOWN group default qlen 100
    link/none
    inet 10.0.1.13/24 brd 10.0.97.255 scope global tun0
    valid_lft forever preferred_lft forever
    “`

    I would like to run arp-scan on the 10.0.1.13/24 range.

    “`
    $ sudo arp-scan -v 10.0.1.0/24
    [sudo] password for jonathan:
    ERROR: Could not obtain MAC address for interface tun0
    “`

    If I spin up a VM and use bridge networking, the 10.0.1.13/24 network shows up as eth0 and I can run arp-scan without a problem.

    My question is, how can I run it on my host OS?

You must be logged in to reply to this topic.